ISSUE 23

 Return to the BUILD


In this issue, we will assemble the anchor winch that will retract the main anchors at the bow of your Titanic.

 

Contents


Parts

Materials: The Base and Cover are both plastic, the Anchor Winch is plastic with metal bits and clasp, and the string appears to be cotton.

Magazine

  • Giant of the Sea – The World’s Biggest Ship’s Dining Room
  • Step-by-Step Instructions

Build


Fitting the Anchor Winch

Step 1

Unwind 6 cm of the ‘cable’ string from the Anchor Winch.

This 6 cm distance is measured from the black spool of the Anchor Winch to the end of the metal clasp:

Push this Anchor Winch down into the Base for Winch Housing.

Make sure the free end of the ‘cable’ string of the Anchor Winch is routed through this slot (arrow below), as shown:

Cover this Base assembly with the Cover for Winch Housing, aligning the screw holes as shown:

Secure these parts together with two (2) AP screws:

Step 2

Retrieve your Hull assembly from Issue 21. Fit this Anchor Winch assembly over the four matching posts at this location.

The opening of the Anchor Winch with the exposed ‘cable’ string should be facing towards the bow (forward), as shown:

Secure the Anchor Winch assembly into place with four (4) AM screws.

This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Thoughts


This Anchor Winch is a spring-loaded self-retracting mechanism. It appears that we will be able to manually lower the main anchors and this winch will raise them back up.

Next Up


Issue 24 – Starboard Section of the Hull, Port Anchor

Leave a Reply

Your email address will not be published. Required fields are marked *